I do not understand why that is relevant to my question at all, when for Totalmix a loopback signal is not accessible!? That was what I wanted for my specific use case. So you can not see in the diagram what is also clearly stated in the text - that you have to use the OUTPUT EQ when Loopback is active? I am still not sure if/ how it is possible to apply an EQ for a S/W playback channel. I tried enabling EQ for record, but that did not change anything. Unfortunately I can not read a block diagram. I'm using another piece of software to accomplish something I would expect TotalMix should support: routing the post EQ hardware output back into another submix.įwiw, I'm really happy with Rogue Amoeba Loopback so far IMO it is an intuitive to use and flexible software patchbay solution. I'm using two playback channels and two hardware outputs to accomplish what should be only one of each, if TotalMix supported EQ and dynamics on software playback channels. While this is some progress, there's still a blocker: I'm not hearing the EQ applied from hardware output AS 1/2 in the headphones mix, which is the same as hardware output ADAT 3/4. Then using another hardware output ADAT 3/4, I mix the post-EQ software playback channel with hardware input AN 1/2. Now I have two software playback channels, one pre-EQ and the other should be post-EQ. Then using the Rogue Amoeba app I captured the loopback signal from hardware input AS 1/2 and routed it to playback channel ADAT 3/4. I used hardware output AS 1/2 to put an EQ on the signal from playback channel AS 1/2, and enabled loopback. I purchased Rogue Amoeba's Loopback app to help with scenarios that I can't figure out how to do with TotalMix.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |